:	Jun 30, 2004

.

Disconnect the battery ground cable.

.

Remove the RH cylinder head assembly.

.

Remove the torque converter flexplate.

.

Remove the cylinder block jackshaft plug.   Drift to release.

.

Using the special tool, remove the RH cassette jackshaft drive, sprocket bolt.   Remove and discard the Torx bolt.

.

Remove the camshaft drive cassette assembly.   Remove the bolt retaining the chain guide.   Remove and discard the O-ring seal.

.

:   Do not disassemble further if the component is removed for access only. Disassemble the cassette assembly.   Release the cable tie.   Remove the sprockets and the chain.   Clean and inspect the components for deterioration.

.

Assemble the cassette assembly.   Install the chain and the sprockets.   Secure with a cable tie.

.

Install the camshaft drive cassette assembly.   Install a new O-ring seal.   Tighten the bolt to 12 Nm (9 lb.ft).

.

Using the special tool, tighten the new jackshaft sprocket bolt to 40 Nm (30 lb.ft), then a further 45 degrees.

.

Install the cylinder block jackshaft plug.   Clean the component mating faces.

.

Install the torque converter flexplate.

.

Install the cylinder head RH assembly.

.

Connect the battery ground cable.